190 Bissell Pl. • Unit A • San Jacinto, CA 92592 • Phone (951) 654-5660 • FAX (951) 654-4070
We are proud to present tooling for your fly press based on the designs from John Crouchet.
Fly Press Tool Extension

All steel collar used to hold your toolsunder th ram of your fly press. Complete with Allen cap screw to lock you rtool in place with.

$65.00 Each
Right Angle Forcer and Base

All steel construction. Ready to use with your fly press to make right angle bends, hot or cold.

$72.00 Each
Hardie Bolster Plate
Use this handy plate to hold your hardy tools that you already have. ths plate fits with the Clamp plate below to hold hardy tools for use in your fly press.

 
$48.00 Each
Clamp Plate
This is an all steel clamp plate for use with a #4 or #5 fly press. It comes with the tee-nuts and cap screws (not pictured) ready to clamp down and go to work.

 
$64.00 Each
Veining Chisel
Use with your fly press to make veining in leaves or to mark stock for twists or decoration. S7 tool steel construction. Comes in small or large.
$25.00 for small

$31.50 for large
Side Butcher
Great for making shoulders or tenons. Tool steel constuction with welded back. Great tool to have for your fly press.
$74.00
Fuller
1/2” fuller for your fly press. Makes reducing or stretching stock almost effortless. Can also be used to make shoulders or other indentations. Tool steel construction with welded steel back.

$74.00
Ball Punch

Comes in 1/8", 3/16", 1/4", 5/16", 3/8", 7/16", and 1/2"

 

$20.00 each

$112.00 for the set of 7