 |
|||
Flypress Tooling |
|||
Right Angle Forcer & Plate
$72.00 each |
|||
Fly Press Tool Extender
$65.00 each
|
|||
|
Download our Catalog
|
|||
Fuller
$74.00 each |
|||
Clamp Plate #4 & #5
$64.00 each |
|||
Hardie Bolster
$48.00 each
|
|||
Side Butcher
$74.00 each
|
|||
Veining Chisel
Small--$25.00 each
Large--$31.50 each |
|||
Tenon Dies
5/16"--3/8"--7/16" or 1/2"--9/16"--5/8" This is a great tool to make quick work of tenons on the flypress. 5/16"--$74.00
1/2"--$74.00
|
|||
|
© Mojave
Southern MachineWorks 2007 Prices are subject to change without notice |
|||
All
steel construction. Ready to use with your fly press to make right angle
bends--hot or cold!
All
steel collar used to hold your tools under the ram of your fly press.
Complete with Allen cap screw to lock your tool in place with. The 1/2"
holder will hold our standard 1/2" tool steel ball, eye, and character
punches.
1/2"
Fuller for your fly press. Makes reducing or stretching stock almost
effortless. Can also be used to make shoulders or other indentations.
Tool steel construction with welded back.
This
is an all steel clamp plate for use with a #4 or #5 fly press. Comes
with the tee nuts and cap screws (not pictured) ready to clamp down
and go to work.
Use
this plate to hold tools that you already have. This plate fits with
the Clamp plate below to hold hardy tools for use in your fly press.
Great
for makng shoulders or tenons. Tool steel construction with welded steel
back. Great tool to have for your flypress.
Use
with your fly press to make veining in leaves, to mark stock for twists,
or for decoration. S7 tool steel constructions. Comes in small or large.
This
is our newest additon to our fly press line of tools. Comes in two sizes: